When do I need supports?
Use support where a layer would otherwise start without adequate material beneath it, after considering orientation and bridging.
Use support where a layer would otherwise start without adequate material beneath it, after considering orientation and bridging.
What to check
Rotate the model and inspect the layer preview before enabling support everywhere. A bridge connects two supported ends and may print without support; an island that begins in mid-air cannot. Test the printer and filament with an overhang or bridge coupon rather than relying on one angle copied from another setup.
When support is necessary, place it under the critical region and tune the interface rather than merely increasing density. UltiMaker's Cura support guide explains that normal support has broad contact and may scar more, while tree support branches around a model and is not suitable for every material. Preview the contact face and removal route before printing an enclosed cavity.