Quick answers, useful caveats
FDM knowledge base
The direct answer comes first. Stick around for the why, the machine-specific caveats and the official source worth opening before you change a setting.

Clean and prepare the correct build surface, confirm the sheet and filament profile, then check the first-layer height.
TroubleshootingWhy is my print stringy?Temperature, retraction, travel, nozzle residue and moisture are common places to investigate.
TroubleshootingWhy does my nozzle keep clogging?Check the filament path, temperature, hotend cooling, material particles and the nozzle procedure in the manual.
TroubleshootingWhat causes layer shifts?Layer shifts happen when the print head or bed loses position. Loose belts or pulley grub screws, obstructions and collisions, and speeds or accelerations beyond what the motors can deliver are the usual causes.
TroubleshootingWhat is ghosting in 3D printing?Ghosting (also called ringing or echoing) is a fading ripple on a wall just after a sharp corner or feature, caused by the printer frame and belts vibrating after a quick change of direction.
Nozzles and toolsShould I use a brass or hardened nozzle?Use brass for ordinary non-abrasive filament unless the material maker calls for wear resistance; use a compatible hardened nozzle for abrasive fills.
Nozzles and toolsIs a 0.6 mm nozzle worth it?It can favour wider lines, higher practical flow and particle-filled materials, while giving up some small-feature resolution.
Slicers and calibrationDoes more infill make a part stronger?It can, but orientation, walls, material and geometry often control the useful failure mode more directly.
Slicers and calibrationWhen do I need supports?Use support where a layer would otherwise start without adequate material beneath it, after considering orientation and bridging.
Slicers and calibrationWhat is pressure advance?Pressure advance pushes extra filament as the print head speeds up and pulls it back as it slows, compensating for pressure lag in the nozzle. It reduces corner bulges and ooze, and needs calibrating per printer and filament.
Slicers and calibrationWhat is maximum volumetric speed?Maximum volumetric speed is a cap, in cubic millimetres per second, on how much plastic the slicer asks the hotend to melt. It depends on filament, nozzle, hotend and extruder, so calibrate it per setup.
MaterialsPLA or PETG for functional parts?Choose by heat, creep, impact, stiffness, environment and printer capability rather than by a universal ranking.
MaterialsDoes filament need drying?Some spools show moisture-related symptoms; follow the filament maker's drying temperature and time rather than guessing.
Design and finishingHow much clearance does a press fit need?There is no universal number: print a coupon using the actual printer, filament, profile and joint geometry.
MaterialsAre 3D-printed parts food-safe?Do not infer food suitability from the polymer name alone; the complete material, colourants, process, surface and cleaning method matter.
TroubleshootingCan I leave a 3D printer unattended?Follow the printer maker's safety instructions and do not assume a previous successful job guarantees the next one.