Knowledge base

Why does my nozzle keep clogging?

Check the filament path, temperature, hotend cooling, material particles and the nozzle procedure in the manual.

By the Layer and Nozzle team ยท Checked 15 November 2026

Check the filament path, temperature, hotend cooling, material particles and the nozzle procedure in the manual.

What to check

Note whether extrusion fails immediately, only after long retractions, or part-way through a slow print. Check the spool can turn, the filament is not crossed, the drive gear is clean, the idler follows its documented setting and the hotend fan runs unobstructed. A repeating mid-print stop can indicate heat creep rather than debris in the bore.

Match nozzle diameter and material: filled filament may require a larger, wear-resistant opening. Use the hotend maker's cold-pull or replacement procedure for that exact model; do not drill the fitted nozzle or heat it with a flame. Prusa's under-extrusion guide lists partial blockage, low temperature, excessive speed and extruder tension among distinct causes, so replacing the nozzle before checking the feed path can miss the fault.

Source