Knowledge base

What is ghosting in 3D printing?

Ghosting (also called ringing or echoing) is a fading ripple on a wall just after a sharp corner or feature, caused by the printer frame and belts vibrating after a quick change of direction.

By the Layer and Nozzle team ยท Checked 15 November 2026

Ghosting is a series of faint ripples that repeat a sharp feature, such as a corner, hole or embossed letter, along the wall just after it, fading as they go. It is vibration: when the print head changes direction abruptly, the machine keeps oscillating for a moment and the nozzle records that wobble on the surface.

Names and causes

The Klipper resonance compensation documentation treats ringing, echoing, ghosting and rippling as the same defect. It notes that ringing usually has mechanical origins: a frame that isn't rigid enough, belts that are loose or too springy, misaligned parts or a heavy moving mass.

What helps

  • Lower speed and acceleration. Simplify3D calls printing too fast the most common cause. Firmware acceleration limits ramp speed up and down before direction changes, and lowering them can reduce ringing further.
  • Tighten what's loose. Simplify3D suggests watching the printer run to find where vibration comes from, such as a loose screw or a cracked bracket.
  • Input shaping. Firmware such as Klipper can measure the printer's ringing frequency and filter it out of motion commands. Klipper notes this also reduces general shaking. If the measured frequency is very low, it suggests stiffening the printer or reducing moving mass first.

Is it really ghosting?

Klipper points out that on its test model, real ringing follows a recognisable pattern after each notch. If the marks don't, the cause is probably mechanical or extrusion-related rather than ringing. Regular horizontal bands that run the full height of a part are more often Z-banding. The layer shifts, ringing and Z-banding guide helps tell them apart, and the print troubleshooter is a quick starting point.

Sources