Knowledge base

What is maximum volumetric speed?

Maximum volumetric speed is a cap, in cubic millimetres per second, on how much plastic the slicer asks the hotend to melt. It depends on filament, nozzle, hotend and extruder, so calibrate it per setup.

By the Layer and Nozzle team · Checked 15 November 2026

Maximum volumetric speed is the most plastic, in mm³/s, that a filament profile allows the slicer to request. It reflects how fast the hotend can melt that filament reliably. When a fast or wide move would exceed it, the slicer slows that move down instead of starving the nozzle.

How flow is worked out

Requested flow is roughly layer height × line width × speed. A 0.2 mm layer at 0.45 mm width and 60 mm/s asks for about 5.4 mm³/s. Thicker layers, wider lines or faster speeds all raise it, which is why a profile can be fine at one layer height and under-extrude at another. The nozzle flow helper on the print troubleshooter page does this sum for you.

Why it varies

The OrcaSlicer volumetric speed calibration page says the value depends on material, machine, nozzle diameter and extruder setup. Even within PLA, brand and colour can change it noticeably. It suggests nozzle temperature towards the upper end of the filament's range if you plan to push flow.

Calibrating it in OrcaSlicer

Orca's test prints a model whose requested flow rises with height. The suggested defaults are 5 to 20 mm³/s in steps of 0.5. You measure the height where the surface starts to fail and calculate: start + (height × step). The page's own worked example comes out at 14.5 mm³/s. It warns that the test is a best case that ignores retraction, so you may want to set the profile 10–20% lower to protect quality and strength. Pushing flow too high risks poor layer adhesion or clogs.

The low end matters too

Running far below the limit isn't automatically safe. Prusa's heat-creep article lists filament not moving through the nozzle fast enough, for example with very thin layers or slow prints, as a contributor to heat creep with PLA. For flow-related symptoms, see the under-extrusion and clogged nozzles guide.

Sources