What is pressure advance?
Pressure advance pushes extra filament as the print head speeds up and pulls it back as it slows, compensating for pressure lag in the nozzle. It reduces corner bulges and ooze, and needs calibrating per printer and filament.
Pressure advance is a firmware feature that compensates for the delay between the extruder moving and plastic actually leaving the nozzle. As the print head speeds up it pushes in a little extra filament, and as it slows it pulls some back, so line width stays even through corners and starts and stops. Marlin calls the equivalent feature Linear Advance.
What it fixes
The Klipper pressure advance documentation says it does two useful things: it reduces ooze during non-printing moves and it reduces blobbing at corners. Without it, you'll often see bulging corners and thin, starved sections just after them, especially at higher speeds.
Why the value is personal
Klipper states that the value depends on the extruder, the nozzle and the filament, and that filament from different makers, or with different pigments, can need significantly different values. Its advice is to calibrate on each printer with each spool. The OrcaSlicer calibration page says to save results to the material profile. It offers separate direct-drive and Bowden versions of each test.
How to calibrate it
OrcaSlicer offers three built-in methods:
- Tower. The value rises one step per millimetre of height. You pick the height with the best corners. It's slower but doesn't depend on first-layer quality.
- Pattern. Nested corner patterns on a few layers, adapted from Andrew Ellis's generator.
- Line. Quick, but Orca warns its accuracy depends heavily on the first layer and suggests bed mesh levelling.
Orca also notes that Marlin printers need Linear Advance enabled in firmware, which not all have by default. On Bambu Lab printers, it says not to tick the "Flow calibration" option.
Pressure advance is not a retraction substitute
A well-tuned value reduces ooze, but stringing still needs the temperature, retraction and moisture checks in the stringing guide. See the slicer comparison for which tools have calibration built in.